Operating Instructions
104
3.7 Using Setup Program
The Setup Program can be used for the following purposes.
• Finding the IP address and port number of the camera connected to your
network.
• Setting up the camera automatically.
• Setting up the camera manually to a Static or a DHCP setting.
• Displaying the Setup page.
Finding the camera
1. Connect the Ethernet cable to the camera following the Getting Started.
• If the Network Camera Setup window does not appear, click "setup.exe"
on the Setup CD-ROM.
2. Insert the Setup CD-ROM into the CD-ROM drive of your PC.
• If the Network Camera Setup window does not appear, click "setup.exe"
on the Setup CD-ROM.
3. Click [Camera Setup].
• When the following dialog box is displayed, click [Unblock].
Displays version information about this
program.
Sets up the camera.
Displays the camera manuals.
If your PC does not have Adobe
®
Acrobat
®
Reader
®
, install it from the Adobe Reader
website.
Installs Network Camera Recorder Trial
Version.
Closes the Setup Program.
To Next Page
Loading...
