Operating Instructions
89
3.1.6 Loading Settings from a Configuration File
The settings can be loaded from a configuration file. If you reset the camera to
factory default, the camera can load its settings from the configuration file.
Notes
• The configuration file has network settings. When the settings are loaded,
the network settings are also loaded as they were saved.
• If you try to update the camera, create a configuration file after updating
the firmware. If there is a firmware version difference between the camera
that you create a configuration file from and the camera that you try to load
settings to, the settings may not be loaded to the camera.
1. Click [Load Settings] on the Maintenance page.
2. Click [Browse...].
3. Select the configuration file on the Choose file dialog box, and click [Open].
• The file name is displayed in the data field.
4. Confirm the file name, and click [Load].
5. Click [Restart].
• The camera restarts, and the Top page is displayed.
To Next Page
Loading...
