Panasonic CF-07 Series

31
Disable
Enable
To the sub-menu
Disable
Enable
No Protection
Protected
To the sub-menu
Enable
Disable
Password on boot
Set Supervisor Password
Hard Disk Lock*
1
User Password Protection
Set User Password*
1
Processor Serial Number*
2
Security Menu
Password on boot [Enable]
Set Supervisor Password: [Enter]
Hard Disk Lock: [Disable]
User Password Protection: [No Protection]
Set User Password: [Enter]
Processor Serial Number: [Disable]
*
1
Setting impossible when the Supervisor Password is not set.
*
2
When [Enable] is set for [Processor Serial Number], it is necessary to shut down the computer once.
( : Default)
Parameters
Setup Utility <Only when the port replicator is connected>
NOTE
When the port replicator is not connected, the computer will start up without the pass-
word even if the password has been set in Setup Utility. Refer to page 7.
When the Setup Utility is started up with the User Password;
[Set Supervisor Password] and [Hard Disk Lock] will not be displayed.
The User Password can be changed only when [User Password Protection] has been
set to [No Protection]. The User Password cannot be deleted.
NOTE