12
Shutting Down Using the Suspend or Hibernation Function
Setting the Suspend or Hibernation Function
Function
Suspend function Hibernation function
Where data is saved to
Memory Hard disk
Speed
Fast Somewhat slow
Requires power supply
Yes (if power is cut, all data is lost) Power is not required to maintain data
1 Run the Setup Utility ( page 41)
2 Using and , select [Power]
3 Using and , select [Power Switch] and press Enter
4 Using and , select [Suspend] or [Hibernation] and press
Enter
5 Press F10 , then select [Yes]
If you want to immediately start up and continue an application after shutting down your
computer, you can do so by using the suspend or hibernation function.
Starting Up Your Computer Quickly
Suspend/Hibernation Functions
Differences between the suspend and hibernation functions
[Off] is factory set.
Suspend Mode
or
Hibernation Mode
The computer should be set for suspend or hibernation ( see the above proce-
dure).
(After releasing your finger from the
power switch, do not touch the power
switch, keyboard or pointing device while
the computer is entering in the suspend
or hibernation modes.)
At the “beep*” sound, release your finger from the power switch. If you con-
tinue to slide the switch and hold it for more than four seconds, the “beep*” will
sound again and the power will go OFF. Data not previously saved will be lost.
Slide the power switch to power on.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode be used instead of the suspend mode.
* When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the Setup
Utility ( page 41) or by the key combination Fn + F4 , there will be no beep sound.
Slide the power switch
With Windows 98, the “Suspend” is called “Standby”.
NOTE
CAUTION
To Next Page
Loading...
