31
Setting the Port Replicator
A port replicator is available as an option (CF-VEB272A). This device eliminates the
hassles of having you connect/disconnect the various cables when carrying your com-
puter around and allows a variety of peripherals to be connected including a head-
phone, microphone, or external display, etc.
The port replicator connects to the expansion bus connector on the back of your com-
puter.
For more detailed information, refer to the operation manual of the port replicator.
Port Replicator
Expansion Bus Connector
To be able to use the serial port B of the port replicator, be sure to follow the steps
below.
1 Turn your computer on.
2 When the message [Press <F2> to enter SETUP] is displayed, press F2 and
then run the Setup Utility.
3 Select [Advanced] menu and set [Serial Port B] to [Enable] and [Device] to [Port
Replicator].
4 Press F10 . At the confirmation message, select [Yes] and press Enter . The
computer will reboot.
The serial port B of the port replicator cannot be used with the default settings.
Hot/Warm Docking and Hot/Warm Undocking are not possible with the port
replicator.
CAUTION
To Next Page
Loading...
