25
When the charge provided by your battery pack is supplied for only a short period of
time, even after fully charging according to the instructions, it may be time to replace
your battery pack. The battery pack is a consumable item and therefore will require
replacement (CF-VZSU04).
Replacing the Battery Pack
1 Power off your computer ( “Starting Up/Shutting Down”)
Do not shut down using the suspend* mode.
*With Windows 98, the “Suspend” is called “Standby”.
Battery Power
Do not touch the terminals on the battery pack. The battery pack may no longer
function properly if the contacts are dirty or damaged.
The battery pack is not charged when the computer is first purchased. Be sure
to charge it before using it for the first time. When the AC adapter is connected
to the computer, charging begins automatically.
Use only the specified battery pack (CF-VZSU04) with your computer.
2 Remove the cover
Turn your computer over and slide the latches.
Lift open the cover holding both sides and remove it.
Remove the inside cover (This is shown by dotted line in the figure).
3 Remove the battery pack
Slide the battery pack outward and gently lift the battery pack.
Cover
Latches
4 Connect the battery pack
Put a battery pack into the computer and slide the battery pack inward
until it is firmly in place.
Inside Cover
(To next page)
In the suspend mode, do not remove/change the battery pack. Re-
moving the pack in the suspend mode will erase your data and may
damage the computer.
CAUTION
CAUTION
To Next Page
Loading...
