55
Your peripheral does not
work (An error occurs
while installing the
driver)
Unable to print
The cursor does not
move from mouse opera-
tions
The device connected to
the serial port does not
work
External mouse or
trackball connected to
the external keyboard/
mouse port does not
work
A PC Card does not work
You do not know the
available RAM module
The RAM module has not
been recognized
The address map for IRQ,
I/O port address, etc. is
unclear
A USB device does not
work
You need to use drivers conforming to Windows 98 Version 4.10.2222A.
Some earlier drivers will no longer work.
For more information, ask the manufacturer of the driver in question.
Check the computer-printer connection.
Make sure the printer is on.
Make sure the printer is in the online state.
Make sure paper is in the printer tray and there is no paper jam.
Has the Setup Utility been used to set [Parallel Port] to [Enable]?
Check your mouse connection, then reboot the computer from the keyboard.
From the keyboard, you may choose to press down on , then select [Shut Down].
Check the connection.
Confirm that the device driver for the serial port works. Refer to the reference
manual of the device.
Confirm that two mouse devices are not connected, one through the external key-
board/mouse port and the other through the serial port.
Confirm that [Device] is set to [Port Replicator] in the Setup Utility.
Try setting [Touch Pad] / [Touchscreen] to disable in the Setup Utility.
Has the Setup Utility been used to set [Serial Port] to [Enable]?
Try setting [Touch Pad] / [Touchscreen] to disable in the Setup Utility.
In some circumstances, if a PS/2 external mouse with a serial interface conversion
function is connected to the port, it may not operate normally. Try connecting it to
the serial port.
If a switch is made to the Touch Pad mode in Panasonic Hand Writing, any external
mouse or trackball connecting to the external keyboard/mouse port will not oper-
ate. Reconnect the device after quitting the Touch Pad mode. When the cursor
cannot be operated via the Touch Pad, reconnect the device. If the device still does
not work, try restarting the computer.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver is installed, the computer must be rebooted.
Check that the proper port settings have been made.
Read the PC Card’s manual. Or, you may need to call the manufacturer of the PC
Card.
Try removing/reinserting the PC Card by following the proper procedure.
( page 29)
In the Setup Utility, confirm that the resources necessary for the PC Card to oper-
ate are not being used.
page 30
Make sure the RAM module has been properly inserted.
Use the RAM module that support the recommended specifications.
Check the address map by going to [View Resources] in [Start] - [Settings] - [Control
Panel] - [System] - [Device Manager] - [Computer] - [Properties]
Make sure a driver is installed.
Contact the manufacturer of the product.
Connecting Peripherals
Dealing With Problems
To Next Page
Loading...
