9
Configuring the Touchscreen
When needed, the touchscreen can be configured using the following steps.
2 Make necessary changes
3 Click [OK]
For more information, click at the upper right corner.
1 Select from the taskbar and then select [TouchScreen]
or select [TouchScreen] in [Start] - [Settings] - [Control
Panel] - [Mouse]
The following screen will appear.
Advanced configuration
Set the advanced settings.
Calibration & Test
Define the calibration setup. Use
this procedure when the cursor
and your (finger) touches do not
appear to agree. (Necessary for
changes in the alignment of the
touchscreen with visual images or
an adjustment of the display reso-
lution.)
Touch the “+” mark on the calibra-
tion screen for about one second.
After the calibration procedure is
executed (e.g., after the nine “+”
marks are touched), the proce-
dure ends when the Enter is
pressed.
The double-click speed of the Touchscreen can be changed in [Tap and Buttons] in
[Start] - [Settings] - [Control Panel] - [Mouse].
Touchscreen
Test
Test for the “Double click settings”.
Double click settings
Set the width and height
of the double click.
NOTE
NOTE
To Next Page
Loading...
