Panasonic CF-M34 - Boot Menu; Exit Menu

56
Setup Utility
Save Values & Exit
Exit Without Saving Changes
Get Default Values*
Load Previous Values
Save Current Values
Refresh Battery
Exit the Setup Utility and save your changes to CMOS.
Exit the Setup Utility without saving your changes to CMOS.
Set the default settings.
Load previous values from CMOS for all Setup items.
Save your changes to CMOS.
Refreshing the Battery ( page 32)
Exit Menu
Save Values & Exit
Exit Without Saving Changes
Get Default Values
Load Previous Values
Save Current Values
Refresh Battery
* This item may not be displayed when starting up the Setup Utility with the User Password.
Parameters
Boot Menu
Floppy Drive
Hard Disk
CD Drive
LAN
The default order is as follows:
[Floppy Drive] [Hard Disk] [CD Drive] [LAN].
To move a device up by one in the order, select the device with and ,and then press
F6 .
To move a device down by one in the order, select the device with and ,and then press
F5 .
Boot First Menu
The device for starting up the Operating System can also be selected during computer
start-up.
After the computer is turned on, the device selection display will appear when ESC is
pressed while “Press <ESC> to enter Boot First Menu” is shown. (When selecting [CD
Drive] from Boot First Menu, if the disc has not been set in the CD drive, it is not
possible to start up from the disc.)
When the setting of the [Boot] menu is changed, the selection screen display will also
change. “Starting Up/Shutting down”
NOTE