Panasonic CF-M34 - Page 6

6
Touch Pad (Advanced)
Changing the mode of the touch pad Windows 98 Windows 2000
1 Select on the taskbar and then select [Touch Pad]* or select [Touch Pad]* in
[Start] - [Settings] - [Control Panel] - [Mouse].
2 To set the Microsoft
®
IntelliMouse
TM
Wheel mode
Add the check mark for [IntelliMouse Wheel mode] of [Scroll Configuration].
To set the original mode
Delete the check mark for [IntelliMouse Wheel mode] of [Scroll Configuration]
and add the check mark for [Horizontal] and/or [Vertical].
3 Select [OK].
* Windows 2000 : [touchpad]
When you want to use an external mouse through the external
keyboard/mouse port
If you are using a USB mouse, the following operation is unnecessary.
1 Windows 98
In [Control Panel] - [System] - [Device Manager], select [touch pad] in [Mouse],
select [Remove] to delete it, then select [OK] to confirm the deletion.
Windows 2000
In [Control Panel] - [System] - [Hardware] - [Device Manager], select [touch pad] in
[Mice and other pointing devices]. Select [Driver] - [Uninstall] to delete it, then
select [OK] to confirm the deletion.
The display will ask you to restart Windows, select [No].
2 Power off your computer and connect the external mouse or trackball device to the
computer.
3 Turn the power on and run the Setup Utility ( page 51). In [Main] menu, set
[Touch Pad] to [Disable] and close the Setup Utility.
4 Following the operating instructions for the connected external mouse, install the
necessary driver.
Do not enter the standby or hibernation mode when an external mouse is connected
to the serial port.