24
11.3.7 Timer setting button
There are 4 types of timer setting by pressing Timer setting button: ON-TIMER, OFF-TIMER, ON-OFF TIMER, OFF-
ON TIMER.
1) SELECT button
When the air conditioner is ON, OFF-TIMER or OFF-ON TIMER can be selected by pressing SELECT
button.
When the air conditioner is turned off, ON-TIMER or ON-OFF-TIMER can be selected.
2) TIMER A and TIMER B
Pressing button TIMER A can change the time for ON-TIMER and OFF-TIMER, off time for OFF-ON Timer, on time for
ON-OFF TIMER; Pressing button TIMER B can change the on time for OFF-ON Timer and off time for ON-OFF Timer
setting.
3) SET/CANCEL button.
Pressing the button to set or cancel the set timer. After the timer setting is determined, “ON” or “OFF” will stop flashing. If
the timer setting is cancelled, “ON” or “OFF” will disappear on the remote control display.
NOTE:
OFF Timer and OFF- ON Timer can only be set during the operation;
Timer operates only once after setting.
If OFF/ON button on the remote control or AUTO Switch on the indoor unit is pressed, the timer setting will be cancelled.
If Auto Restart Control occurs, timer setting will be cancelled.
During the operation, if the ON Timer or ON-OFF Timer is set, the operation will be stopped.
11.3.8 About Cursor Key Which Points To “
““
“OFF”
””
”
On Remote Control
When the ON/OFF button on the remote control is pressed, the cursor key which points to “OFF” will appear or disappear to
indicate the ON/OFF status of the air conditioner.
For some reason (Ex. The signal of the remote control does not reach the signal receiver of the indoor unit.), the display of the
remote control will not correspond with the actual ON/OFF status of the indoor unit:
1. The air conditioner is running but the cursor key which points to “OFF” appears. The air conditioner can be stopped with
any button (Except for “ON/OFF”, “TIMER A”, “TIMER B”, ”SELECT”) pressed.
2.
The air conditioner is on standby, but the cursor key which points to “OFF” disappears. The air conditioner can be started
with any button (Except for “ON/OFF”, “TIMER A”, “TIMER B”, “SELECT”) pressed.
To Next Page
Loading...
