EasyManuals Logo

Panasonic CS-V18DKE User Manual

Panasonic CS-V18DKE
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
When the batteries are inserted for the first time or the
batteries are replaced, you may notice the indications at
remote controls display screen blink continuously and not
functionable. If this condition happens, try to reset the
remote control by pushing the reset terminal with a pointing
device.
You may also do the reset to erase the setting at remote
control and restore back the default setting.
12.4. Remote Control Reset
12.5. Auto OFF/ON Button
The Auto OFF/ON Button (behind the front grille) is used to operate the air conditioner if remote control is misplaced or
mulfunctioning.
Forced cooling operation is possible by pressing the Auto OFF/ON Button for more than 5s where beep sound is heard then
release the button.
User able to select remote control transmission code and toggle remote control signal receiving sound under various setting
mode.
To enter various setting mode:
Press the Auto OFF/ON Button continuously for 5s (beep sound is heard) and release.
Within 20s, press the Auto OFF/ON Button continuously for 5s again (2 beep sound is heard) and release.
Various setting mode has limit up to 20s. Then return to normal operation.
12.5.1. Toggle Remote Control Signal Receiving Sound
Under various setting mode, press the Auto OFF/ON Button to toggle the remote control sound.
Short beep: Turn ON remote control signal receiving sound.
Long beep: Turn OFF remote control signal receiving sound.
After Auto OFF/ON Button is pressed, the 20s counter for various setting mode is restarted.
12.5.2. Select Remote Control Transmission Code
There are 4 types of remote control transmission code could be selected and stored in EEPROM of indoor unit. The indoor unit
will only operate when received signal with same transmission code from remote control. This could prevent signal interference
when there are 2 or more indoor unit installed nearby together.
To change remote control transmission code, short or open jumpers at the remote control printed circuit board.
Under various setting mode, after select the transmission code combination of remote control, press any button of remote
control to transmit a signal to indoor unit. The transmission code will be stored in EEPROM.
After signal is received, the various setting mode is cancelled and return to normal operation.
58
CS-V18DKE CU-V18DKE / CS-V24DKE CU-V24DKE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic CS-V18DKE and is the answer not in the manual?

Panasonic CS-V18DKE Specifications

General IconGeneral
BrandPanasonic
ModelCS-V18DKE
CategoryAir Conditioner
LanguageEnglish

Related product manuals