47
12.3.6 Remote Controller Mounting, Installation and Connection
Remote controller cable
Remote
controller 3
Remote
controller cable
Connector
CAUTION
Install the remote controller cable at least 5 cm away from
electric wires of other appliances to avoid miss-operation
(electromagnetic noise).
■
Remote control mounting location
Allow sufficient space around the remote
controller 3 as shown in the illustration at right.
Install in a place which is away from direct sunlight
and high humidity.
Install in a flat surface to avoid warping of the
remote controller. If installed to a wall with an
uneven surface, damage to the LCD case or
operation problems may result.
Install in a place where the LCD can be easily
seen for operation. (Standard height from the floor
is 1.2 to 1.5 meters.)
Avoid installing the remote controller cable near
refrigerant pipes or drain pipes, else it will cause
electrical shock or fire.
30 mm or more
30
mm
or
more
30
mm
or
more
Remote
controller
lower case
30 mm or more
Remote
controller
3
Lower case
Upper case
■
Remote Controller Installation
Remove the remote controller 3 lower case.
(Insert a flat-tipped screw driver or similar tool 2 to
3 mm into one of the gaps at the bottom of the
case, and twist to open. Refer to the illustration at
right.) Be careful not to damage the lower case.
Do not remove the protective tape which is affixed
to the upper case circuit board when remove the
remote controller lower case.
Secure the lower case to an outlet box or wall.
Refer to (A) or (B) instructions below depending
on your choice of cable installation.
Be sure to use only the screws provided.
Do not over tighten the screws, as it may result in
damage to the lower case.
Upper case
Screw
driver
Lower case
Gaps
Screws
4 or Screws
5
To Next Page
Loading...
