VQT2J45
99
No sound.
Low volume.
Distorted sound.
Cannot hear the desired audio type.
¾ Check the connections and the “Digital Audio Output”
settings. Check the input mode on the amplifier if you have
connected one. (> 10, 11, 12, 81, 82, 87)
¾ Check if TV is muted.
¾ Check if amplifier is muted.
¾ Sound is not output while fast-forwarding during chasing
playback and simultaneous record and playback.
¾ Audio may not be output due to how files were created.
(DivX)
¾ The sound effects will not work when the bitstream signal is
output from the HDMI AV OUT terminal or the DIGITAL
AUDIO OUT terminal.
¾ Audio may not be heard when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
¾ To output audio from a device connected with an HDMI
cable, set “Digital Audio Output” to “HDMI and Optical” in
the Setup menu. (> 82)
¾ Depending on the connected equipment, the sound may be
distorted if this unit is connected with an HDMI cable.
¾ Make sure the connections are pushed in firmly. (> 10, 11,
12, 86, 87, 88)
¾ Try connecting an alternative cable.
Cannot switch audio.
¾ You cannot switch the audio in the following cases.
– When a DVD-R, DVD-R DL, DVD-RW (DVD-Video
format), +R, +R DL or +RW disc is in the disc tray while
DVD drive is selected.
– When the recording mode is XP and “Audio Mode for XP
Recording” is set to “LPCM”. (> 81)
¾ When recording a digital broadcast with multiple audio
channels, this unit will record only the audio channel
selected in “DVB Multi Audio” in the on-screen display. The
audio channel cannot be switched during playback. (> 75)
¾ You have used a digital connection. Set “Dolby Digital” to
“PCM” or connect using audio cables (analogue
connection). (> 81, 87, 88)
¾ There are discs whose audio cannot be changed due to
how the disc was created.
Playback Issues: Sound
DMR-EX99VEB_VQT2J45.book 99 ページ ２０１０年１月７日 木曜日 午後１時４１分
To Next Page
Loading...
