Troubleshooting
VQT4E90
93
The USB device is drawing too much power.
Remove the USB device.
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (> 84)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (> 84)
The media is not supported.
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (> 84)
The unit is hot.
The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message
disappears.
Do not block the cooling fan on the rear of the
unit.
(When a disc is not inserted) A malfunction has
occurred. The unit is trying to restore to the
normal operation. Once the message disappears
you can use the unit again.
If it remains displayed, consult the dealer.
HDMI cannot be output because it is connected to
a model that does not support copyright
protection.
Due to the current disc not having authorised
copyright information, video output is not
performed.
(When a disc is inserted) There was something
unusual detected with the disc or the unit. The
unit is trying to restore to the normal operation.
Once the message disappears you can use the
unit again.
If it remains displayed, consult the dealer.
The unit fails to operate properly. Press [Í/I] on
the main unit to switch the unit to standby mode.
Now press [Í/I] on the main unit again to turn the
unit on.
The HOLD function is activated. (> 85)
There is something unusual. (The service number
displayed after H and F depends on the unit’s
condition.)
Reset the unit as follows:
1 Disconnect the plug from the household mains
socket, wait a few seconds, then reconnect it.
2 Press [Í/I] to turn the power on. (The unit may
be fixed.)
Request service from the dealer. Inform the
dealer of the service number when requesting
service.
REMOVE
START
SW-DL
UNSUPPORT
UPD /
(“∑” stands for a number.)
U59
U61
U76
U77
U88
U99
XHOLD
H or F
(“∑” stands for a number.)
DMR-PWT520&420EB_eng.book 93 ページ ２０１２年３月２３日 金曜日 午後４時４２分
To Next Page
Loading...
Need help?
General
