2
TABLE OF CONTENTS
PAGE PAGE
1 Safety Precautions -----------------------------------------------3
1.1. General Guidelines ----------------------------------------3
1.2. Leakage Current Cold Check ---------------------------3
1.3. Leakage Current Hot Check (See Figure 1)---------3
1.4. How to Discharge the Capacitor on Flash Top
PCB------------------------------------------------------------4
2Warning--------------------------------------------------------------5
2.1. Prevention of Electrostatic Discharge (ESD)
to Electrostatic Sensitive (ES) Devices---------------5
2.2. How to Recycle the Lithium Ion Battery (U.S.
Only)-----------------------------------------------------------5
2.3. Caution for AC Cord (For EB/GC/SG) ----------------6
2.4. How to Replace the Lithium Battery-------------------7
3 Service Navigation------------------------------------------------8
3.1. Introduction --------------------------------------------------8
3.2. General Description About Lead Free Solder
(PbF) ----------------------------------------------------------8
3.3. Important Notice 1:(Other than U.S.A. and
Canadian Market) -----------------------------------------8
3.4. How to Define the Model Suffix (NTSC or PAL
model)---------------------------------------------------------9
4 Specifications ----------------------------------------------------13
5 Location of Controls and Components------------------15
6 Service Mode----------------------------------------------------- 17
6.1. Error Code Memory Function -------------------------17
6.2. ICS (Indication of additional Camera Settings
when picture was taken) function --------------------21
7 Service Fixture & Tools ---------------------------------------23
7.1. Service Fixture and Tools ------------------------------23
7.2. When Replacing the Main PCB ----------------------23
7.3. Service Position ------------------------------------------24
8 Disassembly and Assembly Instructions---------------25
8.1. Disassembly Flow Chart--------------------------------25
8.2. PCB Location----------------------------------------------25
8.3. Disassembly Procedure --------------------------------26
8.4. Disassembly Procedure for the Lens --------------- 32
8.5. Assembly Procedure for Lens ------------------------36
8.6. Removal of the CCD Unit ------------------------------39
8.7. Removal of the Zoom Motor Unit -------------------- 40
8.8. Removal of the Focus Motor Unit --------------------40
8.9. The Applyment of Grease Method-------------------41
9 Measurements and Adjustments --------------------------42
9.1. Matrix Chart for Replaced Part and Necessary
Adjustment-------------------------------------------------42
10 Maintenance ------------------------------------------------------ 43
10.1. Cleaning Lens, Viewfinder and LCD Panel--------43
To Next Page
Loading...
