Panasonic DMC-TZ7EB - Service Mode Functions; Error Code Memory Function and Interpretation

17
6 Service Mode
6.1. Error Code Memory Function
1. General description
This unit is equipped with history of error code memory function, and can be memorized 16 error codes in sequence from the
latest. When the error is occurred more than 16, the oldest error is overwritten in sequence.
The error code is not memorized when the power supply is shut down forcibly (i.e.,when the unit is powered on by the battery,
the battery is pulled out) The error code is memorized to FLASH ROM when the unit has just before powered off.
2. How to display
The error code can be displayed by ordering the following procedure:
• Preparation:
1. Attach the Battery or AC Adaptor with a DC coupler to the unit.
NOTE:
*Since this unit has built-in memory, it can be performed without inserting SD memory card.
*Set the mode dial other than "CLIPBOARD (memo) " mode (such as normal picture/ iA / MS1/MS2/SCN)
to display the error code.
• Step 1. The temporary cancellation of "INITIAL SETTINGS":
Set the REC/PLAYBACK
selector switch to "REC (Camera mark)".
While keep pressing "UP
of Cursor button" and DISPLAY button simultaneously, turn the Power on.
• Step 2. Execute the error code display mode:
Press the "LEFT
of Cursor button", MENU/SET button and DISPLAY button simultaneously.
The display is changed as shown below when the above buttons are pressed simultaneously.
Normal display
→ Error code display → Operation history display → Normal display → .....