Panasonic DMCFZ100 - DIGITAL STILL CAMERA - [Protect]

Advanced (Playback)
- 179 -
You can set protection for pictures you do not want to be deleted by mistake.
•
For details about the icon display during burst picture group playback, refer to “ About display of
[FAVORITE], [PRINT SET] and [PROTECT] icons during playback of burst picture groups.
” on P156.
Select [PROTECT] on the [PLAYBACK] Mode menu. (P28)
Press [‚] to return to the menu screen.
• Press [MENU/SET] to close the menu.
∫ Canceling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].
2 Press 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while canceling protection, the canceling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
• Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in
memory or the card is formatted.
• Even if you do not protect pictures on a card, they cannot be deleted when the card’s
Write-Protect switch is set to [LOCK].
[PROTECT]
Press 3/4 to select the item and then press
[MENU/SET].
• When [SINGLE IN BURST GROUP] or
[MULTI IN BURST GROUP] is selected, press 3/4/2/1 to
select burst picture group, and press [MENU/SET] to proceed to
step
3.
• When [CANCEL] is selected, see “Canceling all the [PROTECT]
settings
”.
Select the picture, and then
press [MENU/SET] to set.
When [MULTI] has been selected
•
Repeat these steps for each picture.
• The settings are canceled when
[MENU/SET] is pressed again.
[SINGLE] [MULTI]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.