Panasonic DMCFZ100 - DIGITAL STILL CAMERA - Inserting and Removing the Card (optional);the Battery

Preparation
- 21 -
Inserting and Removing the Card (optional)/the
Battery
• Turn the power switch to [OFF] and confirm that the lens barrel is retracted.
• Close the flash.
• We recommend using a Panasonic card.
Slide the release lever in the direction of
the arrow and open the card/battery
door.
• Always use genuine Panasonic batteries.
• If you use other batteries, we cannot guarantee
the quality of this product.
Battery: Insert until it is locked by the
lever A being careful about the direction
you insert it. Pull the lever A in the
direction of the arrow to remove the
battery.
Card: Push it fully until it clicks being
careful about the direction you insert it.
To remove the card, push the card until it
clicks, then pull the card out upright.
B:Do not touch the connection terminals of the
card.
•
The card may be damaged if it is not fully inserted.
1:Close the card/battery door.
2:Slide the release lever in the direction
of the arrow.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
LOCK
OPEN
B
LOCK
OPEN