Panasonic DMR-EH50

20
RQT8033
Getting started
Refer to the control reference on page 19.
STEP 2 Channel reception settings
≥When connecting to a television with the VIDEO OUT,
S VIDEO OUT or COMPONENT VIDEO OUT terminal
(➡ 16).
≥When connecting to a television that does not have Q
Link functions (➡ 70).
This unit’s Auto-Setup function automatically tunes all available TV
stations and synchronizes the time when the TV channel that is
broadcasting time and date information is tuned.
≥When connecting to a television with RF socket only
(➡ 17).
1 Turn on the television and select the
appropriate AV input to suit the
connections to this unit.
2 Press [Í DVD] to turn the unit on.
Auto-Setup starts. This takes about 5 minutes.
(When connecting to a television with RF socket only)
Set the new RF output channel to TV (refer to the
instructions for your TV).
Select an unused channel pre-set on your TV and tune it to
the RF output channel number shown on the unit’s display.
3 When Auto-Setup has completed, the Owner ID settings
screen appears.
Press [1] and press the numbered
buttons to enter a 4-digit PIN number.
≥Make a note of the PIN number (don’t forget), as it is not
possible to return to the factory preset.
4 Press [ENTER] twice to store the PIN
number.
The cursor moves to “Name”.
5 Press [1].
6 Press [3, 4] to select a letter and
then press [1].
Repeat this to enter the name.
7 Press [ENTER] to store the name.
8 Press [4] and [1], and then repeat
steps 6, 7 to enter and store “House
No.” and “Postcode”.
9 Press [RETURN].
The Owner ID settings screen disappears.
To stop partway
Press [RETURN].
∫ If the clock setting menu appears
Set the clock manually (➡ 61).
∫ To confirm that stations have been tuned
correctly (➡ 60)
∫ To restart Auto-Setup (➡ 60)
You can also use the following method to restart Auto-Setup.
When the unit is on and stopped
Press and hold [X CH] and [CH W] on the main unit for about 5
seconds.
≥All the settings except for the ratings level, ratings password,
Owner ID and time settings return to the factory preset. The timer
recording programmes are also cancelled.
∫ To enter the satellite/digital terrestrial station’s
name (➡ 60)
The name of the satellite/digital terrestrial station is not set
automatically. (“-- ---” will appear under “Name” in the program list.)
After Auto-Setup is completed, enter the name manually.
∫ If you connect other equipment to AV2 terminal
of this unit
Change the “AV2 Input” in the SETUP menu to match the
connected equipment (➡ 59).
Auto-Setup
(Setup without Q Link functions)
Auto-Setup
Ch 1
Auto-Setup in progress, please wait.
RETURN: to abort
RETURN
Owner ID
RETURN : leave
PIN number
¢¢¢¢
Name
House No.
Postcode
RETURN
EH50.book Page 20 Tuesday, July 5, 2005 11:03 AM