Panasonic DMR-EH50

21
RQT8033
Getting started
≥When connecting to a television with RF socket only (➡ 17)
In some cases, interference (lines or patterning) or a very poor
picture may appear on the TV screen when this unit is connected.
Follow the steps below to change the video playback channel (RF
output channel) to remove the interference.
1 Press [FUNCTIONS] for more than 5
seconds.
2 Press [W X CH] to select a channel
number, which differs by 2 or 3 from
the present channel number.
e.g. If the original channel number was 28, enter 31.
The test pattern screen disappears.
3 Re-tune your TV until you receive the
test pattern screen.
If you can’t see the test pattern screen clearly, repeat step 1
and 2 to select RF output channel again.
4 Press [ENTER] to finish this setting.
This unit doesn’t recognise PlusCode numbers for Satellite stations
or Digital terrestrial stations.
The following operation also allows you to use PlusCode numbers
to make timer recordings for satellite and digital terrestrial stations.
As the settings indicated below are dummy timer recordings,
delete them in step 6.
Preparation
Turn on the Satellite/Digital terrestrial receiver(s).
Select a correct station.
1 Press [VIDEO Plus+].
2 Press the numbered buttons to enter
a PlusCode number for a satellite
station (e.g. Sky One) or digital
terrestrial station.
Press [2] to move back to correct a digit.
3 Press [ENTER].
“-- ---” will appear under “Name”.
4 Press [3, 4] to select the channel or
AV input that is to be used for
recording from the satellite station or
digital terrestrial station.
5 Press [ENTER].
The channel or AV input corresponding to the PlusCode
number is memorised.
Repeat steps 1s5 above until you have set dummy timer
recordings for each of the satellite stations or digital
terrestrial stations that you will make VIDEO Plus+ recordings
from.
6 Press [3] to select each programme
that you have just set and press
[¢ CANCEL] to delete it from the
timer recording list.
To exit the screen
Press [RETURN].
Removing Interference
TV screen
Picture with interference
RF OUTPUT CHANNEL
DVD
CH : 28
SELECT
ENTER
RETURN
RF output channel number appears.
Test pattern screen appears.
Unit’s display
TV screen
RF OUTPUT CHANNEL
DVD
CH : 31
SELECT
ENTER
RETURN
Clear picture
VIDEO Plus+ system for Satellite/
Digital terrestrial stations
Enter PlusCode Number by using 0-9 keys.
VIDEO Plus +
1:58 SP
DVD
30:24 SP
Remain HDD
12:53:00 15/ 7 TUE
TIMER
RECORDING
1:58 SP
DVD
30:24 SP
HDDRemain
12:54:00 15/ 7 TUE
Mode
StopStartName Date
PDC
HDD
DVD
20:0019:0015/ 7 TUE SP OFFHDD
Programme Name
TIMER
RECORDING
1:58 SP
DVD
30:24 SP
HDDRemain
12:56:00 15/ 7 TUE
Mode StopStart No. Date
PDC
HDD
DVD
Name
Disc
space
New Timer Programme
SP
OK
20:00
19:00
AV2
15/ 7 TUE
01
OFF
EH50.book Page 21 Tuesday, July 5, 2005 11:03 AM