57
DP-2330/3030
MAR 2005
Ver. 2.1
DP-2310/3010
(19) Remove the Harness from clamp, disconnect
the Connector.
(20) Remove 2 Screws (51) and 1 Snap Ring (G6).
(21) Remove the Hopper Unit.
Note:
When reinstalling the Hopper Unit, insert the
hooks into the recessed holes on the Developer
Unit as illustrated.
(22) Release 3 Latch Hooks and remove the
Developer Cover (825).
<Removing the Old Developer and Toner>
(23) Stand the Developer Unit as illustrated over a
suitable container and dump the used Developer
and Toner by rotating the Gear.
(24) Clean the Developer Unit with a dry soft cloth.
(25) Reinstall the Hopper Unit.
To Next Page
Loading...
