Panasonic DVD-LV75

Flashes slowly
Flashes
Flashes slowly
Flashes when you press a button
[CHG] indicator
≥Battery pack charge is low. The unit
will turn off after a few minutes.
≥A problem occurred with the battery
pack. Confirm the display on the unit’s
display (➡ page 44).
44
45
RQT5897RQT5897
For Your Reference
For Your Reference
Displays
Troubleshooting Guide
[Í] and [CHG] indicators
This chart shows how these indicators flash under certain conditions.
; refers to the length of time that the indicator is ON.
[Í] indicator
1second
≥The unit is on and the LCD is closed or
the display mode is set to “4 (off)”.
Turn the unit off when you have
finished.
≥The unit is in hold mode or “LINE-IN” is
on. Release hold mode or press
[IN/OUT] to turn off “LINE-IN”.
1second
1second
1second
Maintenance
∫ To clean this unit, wipe with a soft,
dry cloth.
If the surfaces are extremely dirty, use a
soft cloth dipped in a soap-and-water solu-
tion or a weak detergent solution.
≥Use eyeglass cleaner to remove stubborn
dirt from the LCD.
≥Never use alcohol, paint thinner or ben-
zine to clean this unit.
≥Before using chemically treated cloth,
read the instructions that came with the
cloth carefully.
∫ Maintenance of the lens
≥If dust is attached to the lens, remove
dust carefully with an air blower for cam-
era lenses (optional).
≥Be careful not to touch the lens with your
fingers.
Note
The following do not indicate malfunction.
≥A sound is heard from the AC adaptor during recharging.
≥The battery pack warms up after recharging or during use.
≥Small parts of the LCD turn black or radiate different colors (this is a peculiarity of the
LCD).
Problem
The monitor is dark.
The picture is disrupted
during fast forward and
rewind.
No picture on the monitor
(including video from
another unit).
Picture doesn’t appear on
the television (or the size
of the picture seems
wrong).
LCD pixels turn black or
radiate different colors.
Page
19
—
31
31
19
—
32
—
—
33
—
Solution
Adjust the brightness.
Some disruption is normal.
Check connections.
Ensure the video input setting is correct.
≥While you are playing a disc “LINE-IN” should be off.
≥While you are viewing video from other equipment “LINE-
IN” should be on.
Select a picture mode other than “4 (Off)”.
Ensure the power of the connected equipment is on.
Check connections.
Check that the television is on.
Check that the input mode on the television is correct.
Check the settings in “5 TV Aspect”.
The LCD is constructed with precision technology so 99.99 %
of the pixels are active, but of the remaining of 0.01 %, there
are pixels that may be black or emit light constantly.
This phenomenon is not a malfunction.
NO PLAY
“bAT Err” and a number
appear on the display.
Messages do not appear
on the television.
On-Screen Menu Icons
are cut off or are not
displayed at all.
U11
H ∑∑
∑∑ stands for a number.
The unit cannot play this disc.
“bAT Err 1”: A problem has occurred with the battery pack.
Consult your dealer.
“bAT Err 2”: The pack has been recharging for
12 hours but has failed to recharge for some
reason. Recharge again.
“bAT Err 3”: The battery pack has overheated during
recharging. Allow the pack to cool down
before recharging again.
Go to the initial settings menu and turn the On-Screen
Messages on.
Go to the initial settings menu and change the position of
the On-Screen Menu Icons.
Wipe the disc clean.
Trouble has occurred. The number appearing after H
depends on the problem. Turn the unit off and on again.
Alternatively, turn the unit off, disconnect the power source
(AC or battery pack), reconnect the power and turn the unit
on again.
If the service numbers fail to clear, note the service number
and contact a qualified service person.
8
—
—
—
28
28
9
—
rqt5897p40-51.qxd01.1.162:24PM ページ44