Panasonic DVD-LV75

Connection to a 2-channel amplifier or mini-system
(Analogue connection)
(DVD-LV70 and DVD-LV55 have only one AUDIO terminal.)
1 Connect the equipment.
2 Select “2-channel” in “7 Speaker Setting” (➡ page 38).
This figure shows DVD-LV75.
36
37
RQT5897RQT5897
For Your Reference
For Your Reference
AUDIO VIDEO
S VIDEO OUT
5.1CH OUT
AUX IN
R
L
IN/OUT
OPT OUT
Enjoying more powerful sound
Audio input terminal
This unit
(white)
(red)
Stereo connection cable
2-channel analogue amplifier or mini-system
(Including amplifier with Dolby Pro Logic)
∫ To enjoy Dolby Pro Logic (➡ page 46)
As well as the connections shown above, you will need to connect center and sur-
round speakers. See the operating instructions for the other equipment for connection
procedures.
≥Turn V.S.S. off. Surround effects will not work correctly if V.S.S. is on.
(black)
Connection to a 2-channel digital amplifier or mini-system
(Digital connection)
(DVD-LV70 and DVD-LV55 have only one AUDIO terminal.)
1 Connect the equipment.
2
Adjust the settings to suit the equipment you have connected
(➡ page 40, “Digital settings”).
This figure shows DVD-LV75.
AUDIO V
S VIDEO OUT
5.1CH OUT
IN/OUT
OPTICAL
INPUT
OPT OUT
This unit
2-channel digital amplifier
or mini-system
Optical fiber cable
Optical digital
audio input terminal
Do not bend when connecting.
∫ When recording audio
You can connect recording equipment either through an amplifier or directly to this unit.
When connecting directly, use the same method used for connecting a 2-channel amplifier
or mini-system (➡ page 36, 37).
OAnalogue recordingN
You can record to a cassette or MD deck without sound being affected by copy guard if you
use analogue connection.
≥Use a stereo connection cable for analogue connection.
When making analogue recordings, change the setting in “7 Speaker Setting” (➡ page 38,
“Speaker settings”) to “2-channel” even if you have connected 3 or more speakers to an am-
plifier. This will ensure that you record the full soundtrack instead of just the 2 front speaker
channels.
DVD-LV75
ODigital recordingN
You can record the digital signal directly onto an MD.
≥Use an optical fiber cable for digital connection. Ensure the following conditions are met.
≥1. There is no copy guard recorded on the disc.
≥2. The recording equipment can handle a sampling frequency of 48 kHz/16 bit.
≥3. Settings in “6 Digital Audio Output” (➡ page 40, “Digital settings”) have been set as fol-
lows:
≥3. PCM Down Conversion : Yes
≥3. Dolby Digital : PCM
≥3. DTS Digital Surround : PCM
§
§ Off
DVD-LV70
DVD-LV75
rqt5897p28-39.qxd01.1.162:23PM ページ36