≥Charge the battery pack before using it for the
first time.
≥The battery pack can only be recharged when
the unit is off (➡ page 13 “To turn the unit off”).
≥For replacement, see page 4 “Optional acces-
sories”.
1 Attach the battery pack.
1 Confirm that the marks match.
Fit the battery pack firmly so it
clicks into place. Ensure the
mark on the unit matches the
LOCK mark on the battery
pack.
2 Recharge the battery pack.
Connect to the household AC outlet while the
battery pack is attached (➡ page 10).
Note
Refer to “IMPORTANT SAFETY INSTRUC-
SIONS” on pages 6 and 7.
∫ Recharging and play times
§
When brightness is set to the lowest level (➡ page 19).
≥Times shown above depend on operating con-
ditions.
≥The charge is shown on the unit’s display dur-
ing charging. Use this indicator as a guide.
∫ Confirm the battery charge on the unit’s
display
∫ If play time dramatically reduces after
recharging
The battery pack has reached the end of its ser-
vice life (it can be recharged about 300 times).
∫ If the unit is not to be used for a long time
≥Detach the battery pack. (Even if the unit is off,
it still uses some power. This can lead to over
discharging of the battery and malfunction.)
≥Recharge the battery pack when you are ready
to use it again.
∫ To detach
1 Slide and hold in
position.
The unit is in the standby condition (the
[Í] indicator lights) when the AC adap-
tor is connected. The primary circuit is
always “live” as long as the AC adaptor
is connected to an electrical outlet.
Front of this unit
The [CHG] and [Í]
indicators light.
Battery pack
This unit
Recharging
[at 20 oC (68 oF)]
Approx. 4 hours
30 min.
Approx.
5 hours
Approx.
4 hours
DVD-LV55
DVD-LV70
DVD-LV75
LCD on
Approx.
5 hours
§
Approx.
5 hours
§
Approx.
4 hours
§
LCD off
Approx.
7 hours
Approx.
8 hours
Approx.
5 hours
Play time
Preparing the remote
control
Insert the battery
(Lithium battery)
This figure shows DVD-LV75.
∫ Replacing the button-type battery
The battery normally lasts for about a year.
Replace if the remote control fails to operate the
unit when used within the operation range.
Note
Refer to “IMPORTANT SAFETY INSTRUC-
SIONS” on pages 6 and 7.
Operation range
This figure shows DVD-LV75.
Note
≥Do not expose the remote control signal sensor
to bright light.
≥Do not place obstacles between the remote
control signal sensor and the remote control.
≥Do not use another unit’s remote control at the
same time.
Using the AC adaptor
Note
Refer to “
IMPORTANT SAFETY INSTRUC-
SIONS” on page 6.
∫ When the unit is not going to be used
for a long time
The unit consumes 2 W when in standby
mode.
To conserve power, disconnect the AC
adaptor from the AC outlet.
DVD-LV70