9.7. Traverse Gear
1. Disengage the tabs from the traverse gear.
2. Remove the traverse gears B and C.
<Precautions in reassembling the traverse block>
●Take the following precautions when reassembling the
traverse block.
a. Turn traverse gear on the traverse block to let trigger
lever turn rightward. (Front view)
b. Bring cam gear lever to the lever adjusting position
at the end of mechanical chassis unit.
c. Put tabs A and B into slots A and B respectively.
Place tabs C into hooks to mount the traverse block
on mechanical chassis unit. (Slot A... Mechanical
chassis unit, Slot B... Cam gear)
9.8. Optical Pickup Unit
1. Unscrew the screws.
2. Remove the spring holders and the springs.
3. Pull out the drive shaft and guide shaft.
24
DVD-S35E / DVD-S35EB / DVD-S35EG / DVD-S31EG
To Next Page
Loading...
