Panasonic Elite Big PAC-i U-200PZH2E8 - Page 270

77
A
°
°
Press and hold the and buttons
simultaneously for 4 seconds or longer.
The unit No. “X-X” (main unit No.), item code “ ”
(sensor address), and servicing monitor “ ”
(sensor temperature) are displayed on the remote
controller LCD display. (See Fig. 7-10 at right.)
Press the temperature setting / buttons
and select the item code to the address of the
sensor to monitor.
If group control is in effect, press the button
to select the unit to monitor.
Press the temperature setting buttons to select the
item code to change.
Press the button to return to normal remote
controller display.
(3)(4)
(4)
(4)
(3)
(2)
(5) (1)
(1)
(2)
(3)
(4)
(5)
<Procedure of CZ-RTC5B>
1
Keep pressing the , and
buttons simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the
LCD display.
2
Press the or button to see each
menu.
If you wish to see the next screen instantly, press
the or button.
the button.
Change the display from OFF to ON by pressing
the or button. Then press the
button.
Fig. 7-9
3
Press the button. “TEST” will be displayed
on the LCD display.
4
Press the button. Test run will be started.
Test run setting mode screen appears on the LCD
display.
SM830255-00_Single_欧州4方向 TD&SM.indb 22 16/09/21 13:54:54
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Sel. Page [ ] Confirm
20:30 (THU)
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4. Test run
Sel. Page [ ] Confirm
20:30 (THU)
[ ] Confirm
Test run
Change
20:30 (THU)
Test run
ON
20:30 (THU)
START
[ ]
TEST
START[ ]
20:30 (THU)
TEST
FAN SPEED
FLAP
TEST
20:30 (THU)
COOL
MODE
Select “4. Test run” on the LCD display and press
7-20
SM830276-00_欧州向け R32シングル TD＆SM.indb 20 19/02/28 13:33:42