77
The temperature display appears as “- - - -” for units that are not connected.
*
If monitor mode is engaged while normal operation is in progress, only the parts of the LCD display shown in
the figure will change. Other parts continue to display the same information as during normal operation.
Fig. 7-10
A
°
°
Press and hold the and buttons
simultaneously for 4 seconds or longer.
The unit No. “X-X” (main unit No.), item code “ ”
(sensor address), and servicing monitor “ ”
(sensor temperature) are displayed on the remote
controller LCD display. (See Fig. 7-10 at right.)
Press the temperature setting / buttons
and select the item code to the address of the
sensor to monitor.
If group control is in effect, press the button
to select the unit to monitor.
Press the temperature setting buttons to select the
item code to change.
Press the button to return to normal remote
controller display.
(3)(4)
(4)
(4)
(3)
(2)
(5) (1)
(1)
(2)
(3)
(4)
(5)
Sensor Temperature Display Function
(displayed regardless of whether unit
is operating or stopped)
Item code Meaning of Code
Indoor unit data 02 Indoor unit intake temp.
03 Indoor unit heat exchanger temp. (E1)
04 Indoor unit heat exchanger temp. (E2)
05 –
06 –
07 –
08 –
09
Outdoor unit data 0A Discharge temp. (TD)
0b –
0C –
0d Intake temp. (TS)
0E Outdoor unit heat exchanger temp. (C1)
0F Outdoor unit heat exchanger temp. (C2)
10 –
11 Outdoor air temp. ( TO )
12 –
13 Current value (CTL2)
14 Current value (CTL1)
15 Outdoor MV value (MOV1)
16 –
19 Frequency
* Depending on the model, some items may not be displayed.
The procedure below display the sensor temperatures
from the remote controller, indoor unit, and outdoor
unit on the remote controller.
<Procedure of CZ-RTC4>
7-21
SM830276-00_欧州向け R32シングル TD＆SM.indb 21 19/02/28 13:33:42
To Next Page
Loading...
