Panasonic FP-X0 L40MR - Page 224

WR903 FP-X0
Address
Name
Description
R9030
Not used
-
R9031
Not used
-
R9032 COM1 port mode flag
- Turns on when the general-purpose communication
function is being used
- Goes off when any function other than the general-
purpose communication function is being used.
R9033 PR instruction flag
Off: Printing is not executed.
On: Execution is in progress.
R9034
Rewriting during RUN
done flag
Goes on for ony the first scan following completion of a
rewrite during the RUN operation.
R9035
Not used
-
R9036
Not used
-
R9037
COM1 port
communication error
flag
- Goes on if a transmission error occurs during data
communication.
- Goes off when a request is made to send data, using the
F159 (MTRN) instruction.
R9038
COM1 port reception
done flag during
general- purpose serial
communication
- Turns on when the terminator is received during general -
purpose serial communication.
R9039
COM1 port transmission
done flag during
general-purpose serial
communication
- Goes on when transmission has been completed in
general-purpose serial communication.
- Goes off when transmission is requested in general-
purpose serial communication.
R903A
Not used
-
R903B
Not used
-
R903C
Not used
-
R903D
Not used
-
R903E
TOOL port reception
done flag during general
purpose communication
- Turns on when the terminator is received during general -
purpose serial communication.
R903F
TOOL port transmission
done flag during
general-purpose serial
communication
- Goes on when transmission has been completed in
general-purpose serial communication.
- Goes off when transmission is requested in general-
purpose serial communication.
Note) R9030 to R903F can be changed during 1 scan.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com