4 Configure the servo driver
4 Configure the servo driver
1. Use the two rotary switches on the front panel to set the MAC-ID of the servo driver. In
this example, set the address 01 by setting the left switch to 0 and the right switch to 1.
2. Use the PC configuration software PANATERM to configure the MINAS A5/A6 servo
driver. Please refer to other Quick Start Guides to learn how to set parameters in
PANATERM.
Click on the following link to download PANATERM from our Panasonic Download
Center: PC configuration software PANATERM
10 QS2004_V1.0_EN
To Next Page
Loading...
