Panasonic GT12

5-2
5.1 Siemens S7-200 Series
PLC model selection
Select "Siemens S7-200 series".
Usable devices
Bit/Word Device
No.
Memo
Bit Device
Input
I00-I77
Output
Q00-Q77
Bit Memory
M00-M317
Timer(contact)
T00-T255
Counter(contact)
C00-C255
Special Memory
SM00-SM1947
Sequence Control Relay
S00-S317
Word Device
Input
IW0-IW6
Address should be an even number
Output
QW0-QW6
Address should be an even number
Bit Memory
MW0-MW30
Address should be an even number
Timer(current)
T0-T255
Address should be an even number
Counter(current)
C0-C255
Address should be an even number
Special Memory
SMW0-SMW193
Address should be an even number
Sequence Control Relay
SW0-SW30
Address should be an even number
Variable Memory
VW0-VW5118
Address should be an even number
The following list illustrates each expression of PLC device in GTWIN.
When you enter a value of devices, follow below expression.
Expression in PLC
Expression in GTWIN
Bit Device
Q3.2
Q3-2
Word Device
VW100
VW100
Communication Parameters Settings
The example of communication settings of GT and PLC is shown below.
Setting Values for GT
Item
Setting
GT Unit No.
01
PLC Unit No.
02
Baud Rate
9600bps
Data Bits
8
Stop Bits
1
Parity
Even
Setting Values for PLC
Item
Setting
PLC Unit No.
02