Panasonic GT12

8-6
8.3 KV-700 Series Connected using Unit KV-L20R/V
PLC model selection
Select “Keyence KV-700 Series”.
Usable devices
Bit/Word Device
No.
Memo
Bit Device
Relay
00000-59915
Control Relay
CR0000-CR3915
Timer
T000-T511
Counter
C000-C511
High
-speed Counter Comparator CTC0-CTC3
It is not possible to
output it.
Word Device
Data Memory
DM00000-DM39999
Control Memory
CM0000-CM3999
Temporary Data Memory
TM000-TM511
Double Word
Device
Digital Trimmer
AT0-AT7
Timer(set Value)
T/TC000-T/TC511
Counter(set Value)
C/CC000-C/CC511
High-speed Counter Comparator(set
Value)
CTH0-CTH1
Timer(current)
T/TS000-T/TS511
Counter(current)
C/CS000-C/CS511
High-speed Counter Comparator(current)
CTC0-CTC3
Communication Parameters Settings
The example of communication settings of GT and PLC is shown below.
Setting Values for GT (Set in the configuration setting of GTWIN.)
Item
Setting
Baud Rate
9600, 19200, 38400, 57600, 115200 bps
Data Bits
8
Stop Bits
1
Parity
Even
KV-L20R Setting (Port1)
Item
Setting
Operation
KV mode(high link)
Baud rate
9600, 19200, 38400, 57600, 115200 bps
RS/CS flow control
Not used
Note:
- Use the port 1.
- Use a unit editor supplied with the KV BUILDER for the settings of the KV-L20R/V.