2-6
2.1.3 GT03-E
GT03M-E
GT03T-E
○
1
Touch screen
Various screens are displayed here. A touch panel is provided on the liquid crystal display panel, and
switches can be operated and data entered simply by touching the panel.
○
2
USB port
This is a connector for connecting the screen creation tool. The commercial USB cable can be used.
○
3
Operation mode setting switches
Setting the operation mode setting switches as follows when turning on the power supply enables the
setting to inhibit to move to the system menu or enables to clear F-ROM.
The screen (backlight) flashes for a while when the F-ROM clear is executed.
Once the F-ROM clear is complete, the buzzer sounds and "Memory is cleared" is displayed on the
screen. Set the operation mode setting switches to the state in the normal use after confirming this
message, and turn on the power again.
Do not use any settings other than the above settings.
To Next Page
Loading...
