- 138 -
You can confirm the recording screen of this unit from outside using a smartphone.
Preparations before using [Hom.Monitor]
1 Check if the wireless access point is compatible with IEEE802.11b/g/n.
2 Install the smartphone application “Image App” on your smartphone. (l 156)
3 Check if the smartphone is an Android (NFC-compatible), Android (non-NFC-
compatible), or iOS device.
≥ If your smartphone is NFC-compatible, a message asking you to touch the NFC mark on the
device will be displayed when starting up the “Image App”.
4 Set up a Wi-Fi connection between this unit and the wireless access point.
≥ [Easy Connection (WPS)] (l 159)
≥ Searching for wireless access points to set up a connection (l 160)
≥ Setting up a connection manually (l 161)
When the Wi-Fi connection is complete, proceed to “Using [Hom.Monitor]”.
≥ Using [Wi-Fi Easy Setup], you can also set up a Wi-Fi connection in conjunction with the
smartphone application “Image App”. (l 158)
Wi-Fi [HC-V550]/[HC-V550M]/[HC-V250]
[Hom.Monitor]
≥ Switch the Wi-Fi setting to off on your smartphone and use with mobile network such
as 3G.
≥ If [CLOCK SET] (l 20) is not set correctly, [Hom.Monitor] cannot be used.
≥ Check your contract details carefully, as smartphone and internet contract details may
result in high communication charges being incurred, or a limit placed on
communication traffic.
Caution:
This function is not designed for anti-theft or disaster use.
To Next Page
Loading...
