- 139 -
∫ When configuring the home monitor settings using QR code
1 Press Wi-Fi button on this unit and touch [Hom.Monitor].
2 Touch [QR code].
≥ QR code is displayed on the screen of this unit.
3 Turn off the Wi-Fi setting of the smartphone.
4 Start up the smartphone application “Image App”.
≥ (If the device is Android)
When a Wi-Fi connection guidance screen is displayed, select [No].
≥ (If the device is iOS)
If a confirmation message for the Wi-Fi setup is displayed, select [Close].
5 Enable the home monitoring setting from the menu of the smartphone
application “Image App”.
≥ Select [ (MENU)] # [Application function] # [Home Monitor], and enable [Use Home
Monitor].
6 Select [Set connect. dest.] of the smartphone.
7 On the smartphone, select [QR code], and scan the QR code displayed on the
screen of this unit.
≥ A device ID and password will be created. Select [OK] (on your Android device) or [Complete] (on
your iOS device).
8 Touch [NEXT] on the screen of this unit.
≥ Check that the message “Connecting...” has disappeared from this unit.
9 On the smartphone, select [Start Home Monitor] to start home monitoring.
To exit [Hom.Monitor]:
Touch [EXIT] displayed on the screen of this unit or press the Wi-Fi button.
≥ The message is displayed. Touch [YES] to close the indication.
1 Press Wi-Fi button on this unit and touch [Hom.Monitor].
2 Start up the smartphone application “Image App”.
≥ When a Wi-Fi connection guidance screen is displayed, select [NO].
≥ Use the smartphone to start home monitor.
To exit [Hom.Monitor]:
Touch [EXIT] displayed on the screen of this unit or press the Wi-Fi button.
≥ The message is displayed. Touch [YES] to close the indication.
≥ The following operations allow you to register up to ten smartphones. If the number exceeds ten,
smartphone information with the oldest registration date and time will be deleted.
j Setting [Direct Connection Password] to [OFF] and connecting this unit and a smartphone
directly.
When using the home monitor function for the second time or later