Panasonic HC-VX11 - To use the Wireless Multi-Camera function

- 238 -
To use the last connected smartphones
3 Start up the smartphone application “Image App”.
≥ This unit and the smartphone will be connected via Wi-Fi. When the connection to this unit is
complete, the image being captured by the smartphone will be displayed on the Sub Window of
this unit.
≥ If the connection cannot be established or no image appears on the Sub Window, follow the steps
below to set up the connection again:
1 Touch the screen of this unit and touch .
2 Touch [Change Device] on the screen of this unit.
3 Close the smartphone application “Image App”, and then touch [Reset] on the device
registration screen.
4 Touch [YES].
After completing the steps above, follow the procedure from Step 2 onwards in “Selecting this unit’s
SSID on the smartphone to set up a connection” in “When connecting a smartphone to this unit as a
Wireless Sub Camera for the first time (To use the Wireless Multi-Camera function)”. (l 233)
To replace the registered smartphones
To use the Wireless Multi-Camera function
1 Press Wi-Fi button on this unit and touch
[Multi Camera].
2 Touch [ENTER].
A [Multi Camera]
B [EXIT]
1 Press Wi-Fi button on this unit and touch
[Multi Camera].
2 Touch the name of the registered device you
want to replace.
≥ Close the smartphone application “Image App”, and then
follow the procedure from Step 3 on page 233.
≥ To set up a connection by scanning a QR code, follow
the procedure from Step 3 on page 236.
≥ When the connection to this unit is complete, the device
name will be changed to that of the newly-registered
device.
C [Reset]
D [ENTER]
1/2

 
HC-WXF1-VXF1-VX1-V800EBEP-DVQP1585_eng.book 238 ページ ２０１８年２月２２日 木曜日 午後１２時３０分