19
VQT1N87
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always
“live” as long as the AC adaptor is connected to an electrical outlet.
Important:
While the DC cable is connected to the AC adaptor, the battery will not charge.
≥ Do not use the AC cable with any other equipment as it is designed only for this unit. Do not
use the AC cable from other equipment with this unit.
1 Connect the AC cable to the AC adaptor and the AC outlet.
2 Connect the DC cable to the AC adaptor.
3 Connect the DC cable to the DC input terminal [DC IN 9.3V].
Battery capacity indication
≥ The display changes as the battery capacity reduces. ####.
If there is less than 3 minutes remaining, then will become red. If the battery discharges,
then ( ) will flash.
≥ The remaining battery capacity is displayed in minutes when using the Panasonic battery that you
can use for this unit. It may take time to display the remaining battery capacity. The actual time can
vary depending on your actual use.
≥ The maximum amount of remaining battery capacity able to be indicated is 999 minutes. If the
actual remaining time exceeds 999 minutes, the indication will stay green and will not change until
the remaining time falls below 999 minutes.
≥ When turning the mode dial to switch modes, the time indication will turn off momentarily in order to
recalculate the remaining battery capacity time.
≥ When using the AC adaptor or batteries made by other companies, the remaining battery capacity
will not be shown.
Connecting to the AC outlet
3
A DC output terminal
HDCHS9EP-VQT1N87_eng.book 19 ページ ２００８年１月１１日 金曜日 午後７時５２分
To Next Page
Loading...
