Panasonic KV-S1045C - Starting Scanner Applications Automatically

About LED
The status of the scanner can be established by the
condition of the two LED indicators shown in the table
below:
Ready
Error
Start / Stop
A
B
A LED
(Green)
B LED
(Red)
Status
ON OFF Ready
ON Blink (Slow) Caution
Blink (Fast) OFF Warming up
*1
Blink (Slow) OFF Sleep
Blink (Slow) Blink (Slow) Caution / Sleep
OFF ON Error
*1
It will take about 30 seconds to initialize the scanner under the
following conditions:
– Just after turning the power on
– After about 2 hours on sleep mode
– Over about 5 seconds with the ADF door open
14 Installation Manual
Installation