12.2.2. PC Setting
1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory to the one with “RTX_COM” contained.
3. Type “SET RTX_COM=1” from the keyboard (when COM port 1 is
used for the connection).
4. Type “doskey”.
Note:
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data
from address “00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is
read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID
“0018 E0 0E 98” is written.
setfreq adjust Frequency of RFIC Type “setfreq nn nn”.
hookoff off-hook mode on Base Type “hookoff”.
hookon on-hook mode on Base Type “hookon”.
Getchk Read checksum Type “getchk”.
Wreeprom write eeprom Type "wreeprom 01 23 45". "01 23" is
address and "45" is data to be written.
InitBsPIN.bat Initial Base PIN to "0000" Type "initBsPIN"
12.3. TAM Voice Prompt Download
1. Connect the parallel cable from the VOICE PROMPT DOWN
LOADER to TP101, TP102, TP103, TP104 and TP105.
2. Connect the serial cable from the PROM DOWN LOADER to J103,
J104 and J105 of base P.C.B.
3. Switch on the 6V supply.
4. Invoke "vploadenable" batch file from the PC
5. Invoke "go" batch file from the PC.
13. CHECK PROCEDURE (HANDSET)
13.1. Preparation
37
www.freeservicemanuals.info
Digitized in Heiloo, Holland
To Next Page
Loading...
