9. Programmable Features
59
Sending a fax at a specific
time
{#}{4}{1}{2}
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
{0} “OFF” (default)
{1} “ON”
To send a document:
1. If the {FAX} light is OFF, turn it ON by pressing {FAX}.
2. Set the original (page 19).
3. If necessary, change to the desired resolution (page 39) and the desired
contrast (page 39).
4. {MENU} i {#}{4}{1}{2}
5. Press {1} to select “ON”. i {SET}
6. Enter the fax number.
L To enter an item using one-touch dial feature and navigator directory,
see step 3 on “6.3.1 Using the scanner glass”, page 41. (When using
navigator directory, you do not have to press {DIRECTORY} before
pressing {V} or {^}.)
7. {SET}
8. Enter the transmission start time.
L If you selected 12-hour time entry (page 21), press {*} repeatedly to
select AM or PM.
L If you selected 24-hour time entry (page 21), the time is set using 24-
hour time entry.
9. When using the scanner glass, press {SET}. i {START}
When using the auto document feeder, press {SET}.
L The document will be fed into the unit and scanned into memory. The
unit will then send the data at the specified time.
Note:
L To cancel after programming, press {STOP} while the unit is idle, and then
press {SET}.
Setting the Error Correction
Mode (ECM)
{#}{4}{1}{3}
This feature is available when the sending / receiving fax machines are ECM
compatible.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): If there is an error during fax transmission / reception, the
unit will support the communication.
Setting the connecting tone
{#}{4}{1}{6}
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party’s machine.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): You will hear connecting tones.
Note:
L If the ring back tone continues, the other party’s machine may not be a fax
machine or may have run out of paper. Check with the other party.
L The connecting tone volume cannot be adjusted.
Activating the Distinctive
Ring feature
{#}{4}{3}{0}
{0} “OFF” (default)
{1} “ON”
Note:
L This feature may not be available depending on feature #114 setting (page
3).
L See page 53 for details.
Feature/Code Selection
FLB882CX-PFQX2773ZB-OI-en.book Page 59 Friday, October 5, 2007 11:45 AM
To Next Page
Loading...
