EasyManua.ls Logo

Panasonic KX-FP145

Panasonic KX-FP145
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. Programmable Features
51
8.2 Basic features
Code #00: Setting the Quick Setup
QUICK SETUP
PRESS SET
See page 15 for details.
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 21 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 22 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 23 for details.
Code #04: Printing a sending report
SENDING REPORT
MODE=ERROR [±]
To print a sending report for fax transmission
results (page 31).
ERROR (default): A sending report will be
printed only when fax transmission fails.
ON: A sending report will be printed out after
every transmission.
OFF: Sending reports will not be printed out.
Code #06: Changing the ring setting in
TAM/FAX mode (Telephone Answering
Machine/Fax mode)
TAM RING COUNT
RINGS=2 [±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
1, 2 (default), 3, 4, TOLL SAVER or
RINGER OFF. See page 35 for details.
Note:
L Set feature #77 to TAM/FAX (page 54)
beforehand.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=3 [±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select 1, 2, 3 (default) or 4.
Note:
L Set feature #77 to FAX ONLY (page 54)
beforehand.
Code #10: Changing the maximum incoming
message recording time
RECORDING TIME
MODE=VOX [±]
VOX (default): Unlimited.
1 MIN: Up to 1 minute.
Code #11: Setting the remote operation ID
REMOTE TAM ID
ID=111
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is 111.
4. Press {SET}.
5. Press {MENU}.
Code #13: Setting the dialing mode
DIALING MODE
MODE=TONE [±]
If you cannot dial, change this setting depending
on your telephone line service.
TONE (default): For tone dial service.
PULSE: For rotary pulse dial service.
Code #17: Setting the ringer pattern
RINGER PATTERN
MODE=A [±]
You can select A (default), B or C.
FP145.book Page 51 Thursday, January 15, 2004 10:46 AM

Table of Contents

Related product manuals