Panasonic KX-FP145

8. Programmable Features
54
3. Enter a 3-digit number except a number
using digits 0 or 7.
L The default ID is “555”.
4. Press {SET}.
5. Press {MENU}.
Code #52: Setting the mailbox 2 password
BOX2 PASSWORD
ID=
To prevent other users from retrieving your
messages, program a password for mailbox 2.
1. Press {MENU}.
2. Press {#}, then {5}{2}.
3. Enter a 3-digit number except a number
using digits 0 or 7.
L The default ID is “555”.
4. Press {SET}.
5. Press {MENU}.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
MODE=16s [±]
“16s” (default): Maximum recording time is 16
seconds.
“60s”: Maximum recording time is 60 seconds.
See page 42 for details.
Code #55: Greeting message for mailbox 1
BOX1 GREETING
CHECK [±]
See page 46 for details.
Code #56: Greeting message for mailbox 2
BOX2 GREETING
CHECK [±]
See page 46 for details.
Code #60: Setting the message transfer
MESSAGE TRANSFER
MODE=OFF [±]
To transfer recorded incoming messages to
another telephone (page 48), activate this
feature and program the transfer telephone
number.
1. Press {MENU}.
2. Press {#}, then {6}{0}.
3. Press {A} or {B} repeatedly to select “ON”.
4. Press {SET}.
5. Enter the transfer telephone number.
6. Press {SET}.
7. Press {MENU}.
Code #61: Checking, recording or erasing the
transfer greeting message
TRNS-GREETING
CHECK [±]
See page 48 for details.
Code #67: Setting the incoming message
monitor
ICM MONITOR
MODE=ON [±]
To hear an incoming message (ICM) from the
speaker when the answering machine is
recording the message.
“ON” (default): You can monitor the incoming
message.
“OFF”: Deactivates this feature.
Code #70: Calling your pager
PAGER CALL
MODE=OFF [±]
See page 49 for details.
Code #76: Setting the connecting tone
CONNECTING TONE
MODE=ON [±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
“ON” (default): You will hear connecting tones.
“OFF”: Deactivates this feature.
Note:
L If the ring back tone continues, the other
party’s machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
Code #77: Changing the receiving mode in
the AUTO ANSWER setting
AUTO ANSWER
MODE=TAM/FAX [±]
“TAM/FAX” (default): Telephone Answering
Machine/Fax mode (page 35)
“FAX ONLY”: Facsimile only mode (page 35)
FP145.book Page 54 Thursday, January 15, 2004 10:46 AM