Panasonic KX-T7130 - General Programming Instructions; Default System Settings; Programming Telephone Requirements; System Programming Mode Access

18
General Programming Instructions
Default Setting This system has a default factory setting. If any of the program-
ming needs to be changed, you can change the setting by system
programming.
Required Telephone Set You can use any of the following telephones for system program-
ming:
• Proprietary Telephone (PT): KX-T7130, KX-T7030, KX-T7020,
KX-T7050, KX-T7055
• Single Line Telephone (SLT): tone type
All telephones (except KX-T7130 and KX-T7030) do not have
display panels, so you cannot check the setting you have made.
Therefore, please use KX-T7130 or KX-T7030 to check the
programming.
Extensions Used for System programming can only be performed from extension 21.
Programming
To Check the Use KX-T7130 or KX-T7030. When you check the assignment,
Programmed Data set the MEMORY switch on PT to “PROGRAM”.
Enter “#” and the program address.
You cannot check programs #60, #62, #63, #65, #66 and #69, as
they are not displayed on the display panel.
Before Programming To enter the system programming mode:
After Programming To exit the system programming mode:
2
[Off-hook]
[Off-hook]
6
0
6
2
0
6
0
6
6
2