Panasonic KX-TCD290E - Time Settings; Ringer Setup; Handset Settings

Handset Settings
26
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Time settings
Alarm
An alarm will sound for 3 minutes at the set time
once or daily. Set the date and time beforehand
(page 14).
1 Press {j /OK } .
2 Select “ Handset Setup ” , then press {>} .
3 Select “ Time Settings ” , then press {>} .
4 Select “ Alarm ” , then press {>} 2 times.
5 Select an alarm mode, then press {>} .
–
“ Once ” : The alarm will sound once at the
set time. Enter the desired day and month
by selecting 2 digits for each.
–
“ Daily ” : An alarm will sound daily at the
set time.
–
“ Off ” : Turns the alarm off. Press {>}
again, then press {ih} to finish.
6 Enter the desired hour and minute by
selecting 2 digits for each.
L You can select “ AM ” , “ PM ” or 24-hour time
entry by pressing
{*} repeatedly.
7 Press {j /OK } .
8 Select the ringtone that will sound at the set
time, then press {>} .
9 Select “ Save ” , then press {>} .
10 Press {ih} .
Note:
L To stop the alarm, press any dial key.
L When in talk or intercom mode, the alarm will
not sound until the call has ended.
L The alarm will sound at the set time even when
the ringer volume is turned off.
L If you select “ Once ” , the setting will change to
“ Off ” after the alarm sounds.
Ringer setup
Ringer volume
1
Press {j /OK } .
2 Select “ Handset Setup ” , then press {>} .
3 Select “ Ringer Setup ” , then press {>} .
4 Select “ Ringer Volume ” , then press {>} .
5 Press {e} or {v} repeatedly to select the
desired volume.
6 Press {>} .
7 Press {ih} .
To turn off the ringer
1 Follow steps 1 to 4 under “Ringer volume”,
page 26.
2 Press {v} repeatedly until “ Off ” is
displayed.
3 Press {j /OK } .
Note:
L Alarms will sound and the handset will ring for
intercom calls and when paged even if the
ringer is turned off.
L When the ringer is turned off, “ Ring Off ” is
displayed.
Changing ringtones
You can change the ringtone used by the
handset.
“ Ext. Ringtone ” : Selects the ringtone for
outside calls.
“ Int. Ringtone ” : Selects the ringtone for
intercom calls.
1 Press {j /OK } .
2 Select “ Handset Setup ” , then press {>} .
3 Select “ Ringer Setup ” , then press {>} .
4 Select the desired item, then press {>} .
5 Select the desired ringtone, then press {>} .
6 Press {ih} .