Panasonic KX-TCD290E - Listening to Messages

Answering System Features
47
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
not be recorded and the unit will play a
different prerecorded greeting message
asking callers to call again.
Playing back the greeting
message
1
Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Play Greeting”, then press
{>}.
4 Press {ih}.
Erasing the greeting message
If you erase your own greeting message, the
unit will play a prerecorded greeting
message for callers.
1 Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Erase Message”, then press
{>}.
4 Select “Erase Greeting”, then press
{>}.
5 Select “Yes”, then press {>}.
6 Press {ih}.
Listening to messages
Messages are stored and played back
chronologically, from oldest message to
newest.
Listening to new/all messages
When you have new messages:
– the answer on indicator on the base unit
flashes
– the base unit beeps about once a minute if
the message alert feature (page 52) has
been turned on
Using the base unit
Press {>}.
L If new messages have been recorded, the
base unit plays back new messages.
L If there are no new messages, the base
unit plays back all messages.
Note:
L To adjust the speaker volume during
playback, press {>} or {<}.
L After playing back all of the new
messages, the answer on indicator will
stop flashing but will remain lit up when
the answering system is turned on.
Using the handset
1 Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Play New Msg.” or “Play
All Msg.”, then press {>}.
Note:
L To adjust the speaker volume during
playback, press {e} or {v} repeatedly.
L While listening to messages, you can
switch between the receiver and speaker
by pressing {C} or {s}.
Repeating, skipping, stopping,
erasing a message during
playback
L To repeat a message during playback:
– for the base unit, press {<}
– for the handset, press {<}. If pressed
within the first 5 seconds of a message,
the previous message will be played.
L To skip a message during playback:
– for the base unit, press {>}
– for the handset, press {>}.