Panasonic KX-TCD290E - Recording a Voice Memo; Memory Capacity

Answering System Features
48
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
L To stop a message during playback:
– for the base unit, press {■}.
– for the handset, press {9}.
L To erase a message during playback:
– for the base unit, press {4}
– for the handset, press, {*}, {4}.
Erasing all messages
Using the base unit
Press {4} 2 times.
Using the handset
1 Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Erase Message”, then press
{>}.
4 Select “Erase All”, then press {>}.
5 Select “Yes”, then press {>}.
6 Press {ih}.
Note:
L The greeting message is not erased.
Calling back (Caller ID
subscribers only)
If caller information was received for the call,
you can call the caller back while listening to
a message.
1 Press {j/OK} during playback.
2 Select “Call Back”, then press {>}.
Note:
L To edit the number before calling back,
select “Edit and Call”, press {>},
edit the number, then press {C} or {s}.
Recording a voice memo
To leave a private message for yourself or
someone else, you can record up to 3
minutes of voice memo. This memo can be
played back later, either directly or remotely.
1 Press {j/OK}.
2 Select “Answer System”, then press
{>}.
3 Select “Record”, then press {>}.
4 Select “Record Memo”, then press
{>}.
L Hold the handset about 20 cm away
and speak clearly into the microphone.
5 Press {j/OK} to stop recording.
6 Press {ih}.
Note:
L Voice memos are treated as new
messages.
L “Error” is displayed if the voice memo is
less than 1 second long.
Memory capacity
The total recording capacity (including your
greeting message, caller messages, voice
memos, audible call announcements, and
recorded conversations) is about 15
minutes. A maximum of 64 messages can
be recorded.
Note:
L If message memory becomes full,
“Answer Sys. Full” is displayed and
the answer on indicator on the base unit
flashes rapidly. Erase unnecessary
messages (page 47).
L Messages are retained even if a power
failure occurs.