2.00 Some Conventions Used in
This Manual
In this manual “system features” are described in
Section 3 and “station (PITS, SLT, ATT) features”
are described in Section 4 to 6. In these sections,
information for each feature is presented under
the following four headings:
Description, Programming, Conditions, and
Operation.
Description
Defines the feature, describes what it does for the
user, and how it is used.
Programming
Provides tabular listing of items required for
system programming as follows:
<1> <2> <3>
Interpret this table as follows:
<1> shows the required programming items for
the described feature.
<2> shows the reference number for
programming (VT 220 user)
For example, interpret “10-D-4.01” as follows.
10-D-4.01
Title Number
Subsection Number
Section Number
<Example>
4.00 Class of Service
4.01 Class of Service (1/3)
System Programming
Reference
VT Dumb
“System-Class of Service”,
Executive Busy Override
Deny
“System-Numbering Plan”,
Busy Override Deny Set
Busy Override Deny Cancel
11-C-7.00
11-C-11.00
10-D-4.01
10-D-6.04
<3> shows the reference number for
programming (Dumb terminal user)
(Note)
In this manual, all reference numbers are
described using Section Number, Subsection
Number, and Title Number.
<Example>
2.00 System Administration from
a Remote Location
Description
From a remote location, you can perform system
programming, diagnosis and traffic measurements
using a Dumb terminal.
For details about communication parameters, refer
to Section 10-D-7.00 “Communication Interface”.
Conditions
• RMT card (Modem) must be installed in the
system and assign the telephone number of
7.00 Communication Interface
Conditions
Describes the applications and benefits of the
feature, followed by factors to be considered
when the feature is used.
Operation
Provides instructions for a user of PITS
telephone (Section 4), Single Line Telephone
(Section 5) and Attendant Console (Section 6)
individually.
Title Number
1-A-2
Title Number
To Next Page
Loading...
