To Next PageTo Next Page
What to do if I hear a warning tone from my Panasonic PBX telephone?
If you hear a warning tone from your Panasonic PBX telephone, it means the handset was off-hook in an idle status for an extended period. Replace the handset.
Why can't I make an outside call on my Panasonic KX-TD500?
Several reasons may prevent you from making outside calls on your Panasonic PBX system. The telephone could be locked, so try unlocking it. Toll restriction might be activated; in that case, consult your manager or dealer. It's also possible that an account code is required, or a host PBX access code if another PBX is connected. Finally, ensure you dial promptly after going off-hook; otherwise, hang up, go off-hook, and redial.
What to do if I hear a reorder tone or see 'Restricted' displayed on my Panasonic KX-TD500 PBX phone?
If you hear a reorder tone or see 'Restricted' displayed on your Panasonic PBX phone, it could be due to a few reasons. Your telephone might be locked, so try unlocking it. Alternatively, toll restriction could be activated; if so, consult your System Manager or dealer. Lastly, it's possible that an account code is required.
What to do if some Panasonic KX-TD500 features do not work?
If some features on your Panasonic PBX system aren't working, it could be because system management has restricted them; in that case, consult your System Manager. It's also possible that the feature numbers have changed, so confirm the revised number and try again.
Why is my Panasonic Control Unit not ringing?
If your Panasonic Control Unit isn't ringing, the ringer volume might be set to “OFF.” Set the ringer volume selector to either “HIGH” or “LOW.”
Why is speed dialling not working on my Panasonic KX-TD500?
If speed dialling or one-touch dialling isn't working on your Panasonic PBX, the cause may be bad programming. To resolve this, enter the CO line access number (9: [BX], [NZ], [CN], [HK], 0: [SA], 801 through 848) into programming.
Why is there noise in my Panasonic KX-TD500 external paging?
Noise in external paging with your Panasonic PBX is often due to induced noise on the wire between the system and the amplifier. Try using a shielded cable for the connection; a short shielded cable is recommended.
How to resolve Panasonic PBX volume distortion from external music?
Volume distortion from an external music source on your Panasonic PBX is likely caused by an excessive input level. Decrease the output level of the external music source using its volume control.
Why did the background music start suddenly on my Panasonic KX-TD500 PBX?
If the background music started suddenly, turn off the music.
Why is the line disconnected while talking to an outside party on my Panasonic PBX?
If the line is disconnected while talking to an outside party, the time limit may have expired. Consult your dealer to extend the time, if necessary.
General| Digital Extensions | Yes |
|---|---|
| Analog Extensions | Yes |
| Caller ID Support | Yes |
| Automated Attendant | Yes |
| Direct Inward System Access (DISA) | Yes |
| Operating Temperature | 0°C to 40°C |
| Voice Mail Integration | Yes |
| Networking | Yes |
| VoIP Support | Yes (with optional cards) |
| Dimensions | 430 x 415 x 270 mm |
