Private Network
304 Programming Guide
Parameter Leading Digit
Default Blank
Value Range Up to 3 digits consisting of 0-9 or X
Description/Function Specifies the leading one, two or three digits of the number for TIE
calls. Used to determine the trunk group for routing a TIE call.
Note
• "X" can be used as a wild card character which substitutes
any digit in its position.
Reference • 3.1 TIE Line Features (F/G)
– TIE Line Service
Parameter Digits to delete
Default 0
Value Range 0-16
Description/Function Specifies the number of digits to be deleted from the dialled digits.
Reference • 3.1 TIE Line Features (F/G)
– TIE Line Service
Parameter Number to be added
Default Blank
Value Range Up to 20 digits consisting of 0-9
Description/Function Specifies the dialling number to be added to the dialled digits.
Reference • 3.1 TIE Line Features (F/G)
– TIE Line Service
Parameter Trunk Group No.
Default None
Value Range None, 1-48
Description/Function Specifies the trunk group hunt sequence to be used when placing a
TIE call.
The sequence is commonly used by all tenants but trunk group will
be skipped if it does not belong to the same tenant as the caller.
Reference • 3.1 TIE Line Features (F/G)
– TIE Line Service
To Next Page
Loading...
