Panasonic KX-TD500 - Release of BRI;PRI Line While Talking When DISCONNECT Is Received; ARS Call Timeout Mode; Empty Group

System
116 Programming Guide
Parameter 58. Release of BRI/PRI line while talking when
'DISCONNECT' signal is received
Default Release: [HK], Don’t Release: Others
Value Range
1. Release
2. Don't Release
Description/Function Specifies whether or not the system releases the ISDN BRI / PRI
line, when receiving the line disconnection message from the ISDN
Network while the line is in talking.
Reference • 2.3 ISDN Answering Features (F/G)
– Malicious Call Identification (MCID)
• 2.7.15 Identifying Malicious Callers (Malicious Call
Identification [MCID]) (U/M)
Parameter 59. ARS Call Timeout Mode
Default Local Access
Value Range
1. Local Access
2. Disconnect
Description/Function Specifies the outgoing operation mode when the inter-digit timer
expires while making an outgoing call with ARS. If you select
'Local Access' and the timer expires, the system will select a CO
line on a Local CO Line Access basis and return CO dial tone.
Reference • 1.6 Originating Features (F/G)
– Automatic Route Selection (ARS)
Parameter 60. Empty Group
Default Allow
Value Range
1. Allow
2. Disallow
Description/Function Determines whether an Extension Group or an Incoming Group can
be empty (All members logged out). If it is set to 'Disallow,' the
group cannot be empty. At least one extension must be logged in.
Reference • 1.3 System Features (F/G)
– Extension Group
– Incoming Group
• 1.8 Ringing Features (F/G)
– Log-In/Log-Out
• 2.5.5 Leaving a Group (Log-In/Log-Out) (U/M)